【国外标准】 Standard Specification for Fitness Equipment

This specification establishes parameters for the design and manufacture of fitness equipment intended for use by individuals age 12 and above. The design and construction requirements for the following are specified: (1) stability, (2) support, (3) edges, corners, and tube ends, and (4) moving parts in accessible areas such as rotating and reciprocating points. The equipment shall meet the guarding, enclosure, and spacing requirements specified for: (1) squeeze, shear, and crush points, (2) adjustment and locking means, (3) handgrips (integral, applied, and rotating) and foot support, (4) load development and transmitting components such as ropes, belts, chains, and other means, and chain or gear drives, and (5) intrinsic, extrinsic, and endurance loading. The documentation shall include the following: assembly instructions, list of equipment parts, operational instructions, and maintenance instructions. Adequate warnings or warning labels alerting users, third parties, and service personnel to hazards associated with use and service of the equipment shall be provided for consumer, commercial, and institutional fitness equipment. The requirements for site-specific labels and user weight restrictions are specified.1.1 This specification establishes parameters for the design and manufacture of fitness equipment as defined in 3.1.9.1.2 It is intended that these fitness products be used in an indoor setting or environment.1.3 It is the intent of this specification to specify products for use by individuals age 13 and above.1.4 This standard is to be used in conjunction with Test Methods F2571.1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.