【国外标准】 Standard Test Method for Determination of Relative Rotation to Evaluate the Workability of Asphalt Mixture Using Wireless Particle-Size Sensors

5.1 Workability is one of the main factors that influence the compaction quality and ultimately the performance of asphalt pavement. This method uses the relative rotation measured by the wireless particle-size sensor to evaluate the workability of the asphalt mixture.5.2 This test method is used to generate information concerning the workability of an asphalt mixture. Workability characteristics, in turn, can give users insight as to how the mixture will handle and compact in the field.5.3 This method is used to evaluate workability of the mix in a situation where it is being used for research or mix design. It is not intended to be a quality control (QC) evaluation.5.4 This test method can be used to evaluate conventional and modified asphalt mixtures to achieve the best workability at an appropriate compaction temperature. The test method can be used to determine the compaction temperature and optimal dosage rate of additives or modifiers to achieve the best workability for the modified asphalt mixtures, such as polymer modified, crumb rubber modified, waste plastic modified, etc.5.5 This test method is appropriate for laboratory-produced mixtures and plant-produced mixtures, regardless of the type or grade of the binder, the type or gradation of the aggregates, and whether RAP, WMA additives, or other modifiers are used in the asphalt mixture.NOTE 1: The quality of the results produced by this standard is dependent on the competence of the personnel performing the procedure and the capability, calibration, and maintenance of the equipment used. Agencies that meet the criteria of Specification D3666 are generally considered capable of competent and objective testing, sampling, inspection, etc. Users of this standard are cautioned that compliance with Specification D3666 alone does not completely ensure reliable results. Reliable results depend on many factors; following the suggestions of Specification D3666 or some similar acceptable guideline provides a means of evaluating and controlling some of those factors.1.1 This test method covers the determination of relative rotation to evaluate the workability of asphalt mixture during compaction using a wireless particle-size sensor. It is applicable to asphalt mixture being compacted using the Superpave Gyratory Compactor (SGC).1.2 This test method is appropriate for use to determine the relative rotation of laboratory-produced and plant-produced asphalt mixtures, regardless of the type or gradation of the aggregates, and whether reclaimed asphalt pavement (RAP), warm mix asphalt (WMA) additives, or any type of modifiers are used in the asphalt mixture.1.3 Units—The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.1.4 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered requirements of the standard.1.5 Since a complete precision and bias statement for this standard has not been developed, the test method is to be used for research and informational purposes only. Therefore, this standard should not be used for acceptance or rejection of a material for purchasing purposes.1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.