【国外标准】 Standard Test Method for Fungicides for Controlling Sapstain and Mold on Unseasoned Lumber (Laboratory Method)

5.1 This test method is useful as a screening procedure for selecting fungicides or formulations for more rigorous field evaluation.1.1 This (laboratory) test method is used for determining the minimum concentration of fungicide, or formulation of fungicides, that is effective in preventing biodeterioration by sapstain fungi and molds in selected species of wood under optimum laboratory conditions.NOTE 1: From the results of this test, commercial treating solution concentrations cannot be estimated without further field tests.1.2 The requirements for test materials and procedures are discussed in the following order:  SectionSummary of Test Method 4Apparatus 6Reagents 7Wood 8Test Fungi 9Culture Media 10Preparation of Inoculum 11Preparation of Test Chambers 12Treatment of Samples 13Inoculation and Incubation 14Evaluation of the Test 15Report 161.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.