
【国外标准】 Standard Guide for Use of High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane with an Integral Wearing Surface
本网站 发布时间:
2024-02-28
开通会员免费在线看70000余条国内标准,赠送文本下载次数,单本最低仅合13.3元!还可享标准出版进度查询、定制跟踪推送、标准查新等超多特权!  
查看详情>>

适用范围:
4.1 This guide is divided into two sections which provide design and specification guidelines for the use of a cold liquid-applied elastomeric membrane with integral wearing surface for waterproofing building decks in building areas to be occupied by personnel, vehicles, or equipment.4.2 The intent of Sections 5 – 11, Design Considerations, is to provide information and design guidelines where a waterproofing membrane with integral wearing surface is to be used. The intent of the remaining sections is to provide minimum guide specifications for the use of the purchaser and the seller in contract documents.4.3 Where the state of the art is such that criteria for a particular condition is not as yet firmly established or has numerous variables that require consideration, reference is made to the applicable portion of Sections 5 – 11 that covers the particular area of concern. Section 16 describes the repair, rehabilitation, and replacement of the membrane.1.1 This guide describes the design and installation of cold liquid-applied elastomeric waterproofing membrane systems that have an integral wearing surface. The cold liquid-applied elastomeric waterproofing membrane (membrane) to which this guide refers is specified in Specification C957/C957M.1.2 Concrete Slab-on-Grade—Waterproofing the upper surface of a concrete slab-on-grade presents special problems due to the possibility of negative hydrostatic pressure causing loss of bond to the substrate. Consideration of these problems is beyond the scope of this guide. Consult the membrane manufacturer for recommendations when this situation exists.1.3 The committee having jurisdiction for this guide is not aware of any similar ISO standard.1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 15.4.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
标准号:
ASTM C1127/C1127M-15(2023)
标准名称:
Standard Guide for Use of High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane with an Integral Wearing Surface
英文名称:
Standard Guide for Use of High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane with an Integral Wearing Surface标准状态:
Active-
发布日期:
-
实施日期:
出版语种:
- 推荐标准
- AS 4276.15:2014 Water microbiology Examination for Vibrio cholerae
- AS 5013.15-2004 Food microbiology Microbiology - General guidance for enumeration of presumptive Escherichia coli - Most probable number technique
- AS IEC 60300.3.15-2011 Dependability management Application guide - Engineering of system dependability
- AS ISO 14520.15-2009 Gaseous fire-extinguishing systems - Physical properties and system design IG-541 extinguishant (ISO 14520-15:2005, MOD)
- AS/NZS 2023:1995 Baths for ablutionary purposes
- AS/NZS 3200.2.15:1994 Approval and test specification - Medical electrical equipment Particular requirements for safety - Capacitor discharge X-ray generators
- AS/NZS 3350.2.15:1997 Safety of household and similar electrical appliances Particular requirements - Appliances for heating liquids
- AS/NZS 3350.2.15:1997/Amdt 1:1997 Safety of household and similar electrical appliances - Particular requirements - Appliances for heating liquids
- AS/NZS 3350.2.15:1997/Amdt 3:2001 Safety of household and similar electrical appliances - Particular requirements - Appliances for heating liquids
- AS/NZS 3350.2.15:1997/Amdt 4:2001 Safety of household and similar electrical appliances - Particular requirements - Appliances for heating liquids
- AS/NZS 3350.2.15:2002/Amdt 1:2003 Safety of household and similar electrical appliances Particular requirements for appliances for heating liquids (IEC 60335-2-15:1995, MOD)
- AS/NZS 3350.2.15:2002/Amdt 2:2003 Safety of household and similar electrical appliances - Particular requirements for appliances for heating liquids (IEC 60335-2-15:1995, MOD)
- AS/NZS 3350.2.15:2002/Amdt 3:2007 Safety of household and similar electrical appliances Particular requirements for appliances for heating liquids (IEC 60335-2-15:1995)
- AS/NZS 3750.15:1998 (R2013) Paints for steel structures Inorganic zinc silicate paint
- AS/NZS 4456.15:1997 Masonry units and segmental pavers - Methods of test Determining lateral modulus of rupture