【国外标准】 Standard Specification for Steel Sheet, as Cold-Reduced, for Conversion to Annealed Cold-Rolled Steel Sheet, and Hot Dip Metallic-Coated Steel Sheet

This specification covers requirements for as cold-reduced, steel sheet in coils intended for conversion into cold-rolled steel sheet on continuous annealing lines, and metallic-coated steel sheet on continuous hot-dip coating lines. As cold-reduced steel sheet in coils comes in a semi-finished form and is produced to thickness requirements expressed to 0.001 in. (0.01 mm). Due to the high degree of cold reduction, as cold-reduced steel sheet exhibits high tensile strength with very minimal ductility.This specification prescribes the requirements for chemical composition; mechanical properties; dimensions and mass; flatness, width, and coil size; product finish and condition; and packaging and marking.1.1 This specification covers the requirements for as cold-reduced steel sheet in coils intended for conversion into cold-rolled steel sheet on continuous annealing lines, and metallic-coated steel sheet on continuous hot-dip coating lines.1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.