【国外标准】 Standard Practice for Laboratory Preparation of Gelled Vehicles Using a Resin Kettle

5.1 This practice provides a means of preparing gel vehicles in laboratory equipment that most closely resembles production reactors. It can be used to predict the performance of gel vehicle components (resins, gellants, alkyds, etc.) in the user's equipment.5.2 An ample amount of gel vehicle can be prepared for use in preparing inks for press testing.1.1 This practice covers a laboratory procedure for the gelation of a resin solution, ink varnish, or vehicle using a resin kettle.1.2 Guidance in preparing gelled vehicle samples suitable for use in laboratory sample quantity oil-based printing inks is provided.1.3 The procedure outlined is not intended as a means of rating or evaluating resin or vehicle gelability, and is applicable only if the solutions, varnishes, or vehicles produced are of a rheology that is measurable by conventional ink and varnish industry viscometers or rheometers.1.4 The values stated in SI units of measurement are to be regarded as the standard. The values given in parentheses are for information only.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.