【国外标准】 Standard Specification for Design and Performance of a Light Sport Glider

This specification covers airworthiness requirements for the design of a powered or non-powered fixed wing light sport aircraft, a “glider.” Stability shall be shown by a tendency for the glider to return toward steady flight after: (1) a “push” from steady flight that results in a speed increase, followed by a non-abrupt release of the pitch control; and (2) a “pull” from steady flight that results in a speed decrease, followed by a non-abrupt release of the pitch control. Strength requirements are specified in terms of limit loads (the maximum loads to be expected in service) and ultimate loads (limit loads multiplied by prescribed factors of safety). The suitability of each structural design detail and part having an important bearing on safety shall be established by test. Each combination of engine, exhaust, cooling and fuel system on a powered glider must be compatible with the glider, and function in a safe and satisfactory manner within the operational limits of the glider and powerplant. Each aircraft shall include Aircraft Operating Instructions (AOI).1.1 This specification covers airworthiness requirements for the design of a powered or non-powered fixed wing light sport aircraft, a “glider.”1.2 This specification is applicable to the design of a light sport aircraft glider as defined by regulations and limited to day VFR flight.1.3 A glider for the purposes of this specification is defined as a heavier than air aircraft that remains airborne through the dynamic reaction of the air with a fixed wing and in which the ability to remain aloft in free flight does not depend on the propulsion from a power plant. A powered glider is defined for the purposes of this specification as a glider equipped with a power plant in which the flight characteristics are those of a glider when the power plant is not in operation.1.4 The values stated in SI units are to be regarded as standard. The values given in parenthesis are for information only.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory requirements prior to use.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.