【国外标准】 Standard Specification for Copper-Alloy Plate and Sheet for Pressure Vessels, Condensers, and Heat Exchangers

This specification establishes the requirements for plates, sheets, and circles cut from plates and sheets made of UNS C36500, C44300, C44400, C44500, C46400, C46500, C61300, C61400, C63000, C63200, C70600, C70620, C71500, C71520, or C72200 copper alloy. These materials are recommended for use in pressure vessels, condensers, and heat exchangers. The materials are manufactured by either hot rolling or forging and finished by such cold working and annealing to produce products of the required dimensions and properties. Tempers available under this specification are as hot rolled and hot rolled and annealed. The products manufactured for ASME Boiler and Pressure Vessel code applications must be certified to the hot rolled and annealed temper while all other products can either have hot rolled or hot rolled and annealed temper. This specification also contains information on the required material chemical compositions, densities, and tensile properties.1.1 This specification2 establishes the requirements for copper-alloy plate, sheet, and circles cut from plate and sheet for pressure vessels, condensers, and heat exchangers. The following alloys are covered:Copper Alloy Previously Used Designation   C36500 Leaded Muntz MetalC44300 Admirality, ArsenicalC44400 Admirality, AntimonialC44500 Admirality, PhosphorizedC46400 Naval Brass, UninhibitedC46500 Naval Brass, ArsenicalC61300 Aluminum BronzeC61400 Aluminum Bronze DC63000 10 % Aluminum-Nickel BronzeC63200 9 % Aluminum-Nickel BronzeC70600 90-10 Copper NickelC70620 90-10 Copper Nickel-(modified for welding)C71500 70-30 Copper NickelC71520 70-30 Copper Nickel-(modified for welding)C72200 . . .1.2 Units—The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.