【国外标准】 Standard Specification for Tenderness Marketing Claims Associated with Meat Cuts Derived from Beef

This specification covers requirements for incorporating a tenderness marketing claim to finished labelling, advertisements, or promotions, or a combination thereof, associated with beef cuts to distinguish product value in the marketplace. The claim requirements are the certified tender and certified very tender. This specification also notes that the beef cuts that are being considered for the tenderness marketing claim will be certified through third party auditing activities.1.1 This specification covers requirements for incorporating a tenderness marketing claim to finished labeling, advertisements, or promotions, or a combination thereof, associated with beef cuts to distinguish product value in the marketplace.1.2 The marketing claim requirements in this specification can be used by all parties interested in highlighting production and marketing practices of tender beef muscles/cuts in finished labeling, advertisements, or promotions, or a combination thereof, to distinguish their products in the marketplace. A tenderness marketing claim standard for beef cuts facilitates communication by enhancing the understanding of finished product expectations among producers, processors, and consumers.1.3 Beef cuts being considered for this tenderness marketing claim will be certified through third party auditing activities. Firms seeking these services must adhere to the standard practices associated with this specification as recognized by the certifying body.1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.