【国外标准】 Standard Specification for Self-Adhering Polymer Modified Bituminous Sheet Materials Used as Steep Roofing Underlayment for Ice Dam Protection

This specification covers the standards for polymer modified bituminous sheet materials proposed for use as underlayment on roof eaves, or valleys, or both, to prevent leakage of shingle, tile or metal roofs from water back-up due to ice dams. The underlayment sheet shall comply with the physical requirements which include thickness, maximum load, elongation, adhesion to plywood, thermal stability, flexibility, tear resistance, moisture vapor permeance, sealability, and slip resistance. The underlayment sheet shall not crack, as well, nor be too sticky as to cause damage upon being unrolled.1.1 This specification covers polymer modified bituminous sheet materials intended for use as underlayment on roof eaves, or valleys, or both, to prevent leakage of shingle, tile, or metal roofs from water back-up due to ice dams.1.2 These underlayment sheets have a sticky adhesive layer which is exposed by removal of a protective sheet. The top surface is suitable to work on during the application of the exposed roofing.1.3 Table of Contents:   Section 1Referenced Documents 2Terminology 3Workmanship, Finish, and Appearance 4Physical Requirements 5Sampling 6Test Methods 7     Conditioning 7.1     Thickness 7.2     Maximum Load and Elongation at Break 7.3     Adhesion to Plywood 7.4     Thermal Stability 7.5     Flexibility at –29 °C [–20 °F] 7.6     Tear Resistance 7.7     Moisture Vapor Permeability 7.8     Capability to Seal Around Nail         (Head of Water Test) 7.9     Waterproof Integrity of Side Lap Seam         (Head of Water Test) 7.10Inspection 8Rejection and Rehearing 9Packaging and Package Marking 10Keywords 111.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.