
【国外标准】 Standard Practice for Electrolytic Extraction of Phases from Ni and Ni-Fe Base Superalloys Using a Hydrochloric-Methanol Electrolyte (Withdrawn 2018)
本网站 发布时间:
2024-02-28
- ASTM E963-95(2017)
- Withdrawn, No replacement
- 定价: 0元 / 折扣价: 0 元
- 在线阅读
开通会员免费在线看70000余条国内标准,赠送文本下载次数,单本最低仅合13.3元!还可享标准出版进度查询、定制跟踪推送、标准查新等超多特权!  
查看详情>>

适用范围:
3.1 This practice can be used to extract carbides, borides, TCP and GCP phases, which can then be qualitatively or quantitatively analyzed by X-ray diffraction or microanalysis.23.2 Careful control of parameters is necessary for reproducible quantitative results. Within a given laboratory, such results can be obtained routinely; however, caution must be exercised when comparing quantitative results from different laboratories.33.3 Comparable qualitative results can be obtained routinely among different laboratories using this procedure.31.1 This practice covers a procedure for the isolation of carbides, borides, TCP (topologically close-packed), and GCP (geometrically close-packed) phases (Note 1) in nickel and nickel-iron base gamma prime strengthened alloys. Contamination of the extracted residue by coarse matrix (gamma) or gamma prime particles, or both, reflects the condition of the alloy rather than the techniques mentioned in this procedure.1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. (See 4.3.2.1 and 5.1.1.)NOTE 1: Ni3 Ti (eta phase) has been found to be soluble in the electrolyte for some alloys.FIG. 1 Schematic Diagram of Extraction Cell1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
标准号:
ASTM E963-95(2017)
标准名称:
Standard Practice for Electrolytic Extraction of Phases from Ni and Ni-Fe Base Superalloys Using a Hydrochloric-Methanol Electrolyte (Withdrawn 2018)
英文名称:
Standard Practice for Electrolytic Extraction of Phases from Ni and Ni-Fe Base Superalloys Using a Hydrochloric-Methanol Electrolyte (Withdrawn 2018)标准状态:
Withdrawn, No replacement-
发布日期:
-
实施日期:
出版语种:
- 推荐标准
- ASTM D817-12(2019) Standard Test Methods of Testing Cellulose Acetate Propionate and Cellulose Acetate Butyrate
- ASTM D8170-20 Standard Guide for Using Disposable Handheld Soil Core Samplers for the Collection and Storage of Soil for Volatile Organic Analysis
- ASTM D8171-18 Standard Test Methods for Density Determination of Flax Fiber
- ASTM D8174-18 Standard Test Method for Finite Flash Point Determination of Liquid Wastes by Small-Scale Closed Cup Tester
- ASTM D8176-18(2023) Standard Test Method for Mechanically Tapped Density of Activated Carbon (Powdered and Fine Mesh)
- ASTM D8180-23 Standard Specification for Rerefined Mineral Insulating Liquid Used in Electrical Apparatus
- ASTM D8181-19 Standard Specification for Microemulsion Blendstock for Preparing Microemulsion Test Fuel Oils
- ASTM D8186-18 Standard Test Method for Measurement of Impurities in Graphite by Electrothermal Vaporization Inductively Coupled Plasma Optical Emission Spectrometry (ETV-ICP OES)
- ASTM D8188-23 Standard Test Method for Determination of Density and Relative Density of Asphalt, Semi-Solid Bituminous Materials, and Soft-Tar Pitch by Use of a Digital Density Meter (U-Tube)
- ASTM D8192-23 Standard Test Method for Hardness in Colored and Colorless Water
- ASTM D8195-18 Standard Classification System and Basis for Specification for Polyethylene Terephthalate Film and Sheeting
- ASTM D8198-18 Standard Specification for Hydraulically Applied 100 % Wood Fiber Mulches
- ASTM D8199-20 Standard Test Method for Determining the Specific Strength of Hydraulically Applied Fiber Matrix Products for Erosion Control
- ASTM D820-93(2023) Standard Test Methods for Chemical Analysis of Soaps Containing Synthetic Detergents
- ASTM D8200-22 Standard Practice for Creating a Correlation to Compare Particle Size Distribution Results of Proppants by Dynamic Imaging Analyzers and Sieves