【国外标准】 Standard Test Method for Carbon Black Content in Olefin Plastics

4.1 The information provided by this test method is useful for manufacturing quality control, technical service, and research purposes; and is required by various material specifications and for the calculation of optical absorptivity.4.2 Test Method D4218 is available for determining the carbon black content of polyethylene compounds if so desired.1.1 This test method covers the determination of the carbon black content in polyethylene, polypropylene, and polybutylene plastics. Its use with acrylic or other polar monomer modifications which might affect the accuracy is not recommended. Determinations of carbon black content are made gravimetrically after pyrolysis of the sample under nitrogen. This test method is not applicable to compositions that contain nonvolatile pigments or fillers other than carbon black.1.1.1 This test method is not applicable to materials containing brominated flame retardant additives at the end.1.2 The values stated in SI units are to be regarded as standard. The values in parentheses are given for information only.1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.NOTE 1: This standard and ISO 6964-1986(E) address the same subject matter, but differ in technical content.1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.