【国外标准】 Standard Test Methods for Film-Insulated Magnet Wire

7.1 Bond strength values obtained by flexural tests provide information with regard to the bond strength of a particular self-bonding outer coating in combination with a particular round film-insulated magnet wire when measured under conditions described in this test method.1.1 These test methods cover procedures for testing film-insulated magnet wire that is used in electrical apparatus. These test methods are intended primarily for the evaluation of the electrical insulating materials used. The intent is that these test methods be used, except where modified, by individual specifications for particular applications.1.2 These test methods present different procedures for evaluating given properties of round, rectangular or square, copper or aluminum film-insulated magnet wire.1.3 The values stated in inch-pound units are the standard. The SI units in parentheses are provided for information only.1.4 The test methods appear in the following sections:  SectionsBond Strength  4 – 12Burnout (AC Overload Resistance) 13 – 21Chemical Resistance 22 – 28Coefficient of Friction 29 – 37Continuity, DC High Voltage 38 – 45Continuity, DC Low Voltage 46 – 53Completeness of Cure 54 – 60Cut-Through Temperature (Thermoplastic Flow) 61 – 68Dielectric Breakdown AC Voltage 69 – 75Dielectric Breakdown AC Voltage after Bending 76 – 82Dielectric Breakdown AC Voltage at Elevated Temperatures 83 – 89Dielectric Breakdown AC Voltage after Conditioning in Refrigerant Atmosphere 90 – 99Dimensional Measurement 100 – 106Dissipation Factor Measurement 107 – 114Electrical Resistance 115 – 121Elongation 122 – 129Extractables, Refrigerant 130 – 140Film Adherence and Flexibility 141 – 148Formability:   a) Elastic Ratio 152 b) Low Stress Elongation 153 c) Spring Back 154-155Heat Shock 156 – 162Oiliness 163 – 169Scrape Resistance, Unidirectional 170 – 177Solderability 178 – 185Resistance to Insulating Liquids and Hydrolytic Stability 186 – 1951.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 9.5, 19.1, 19.3, 19.8, 52.1, 58, 59.1, 74.1, 112.1, 135.4, and 182.3.NOTE 1: This test method is related to IEC 60851. Since both methods contain multiple test procedures, many procedures are technically equivalent while others differ significantly.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.