【国外标准】 Standard Specification for Industrial Rubber Finger Cots

This specification covers the requirements for finger cots made from natural rubber latex. The purpose of this specification is to obtain consistent performance among products produced in various locations or at various times in the same location. The material shall be classified according to type; Type 1 and Type 2 and according to sizes; small, medium, large, and extra large. Test methods shall be performed to comply with the dimensions, physical properties, and inspection requirements of the material.1.1 This specification covers the requirements for finger cots used in industrial applications which are made from natural rubber latex or a synthetic nitrile polymer. The purpose of this specification is to obtain consistent performance among products produced in various locations or at various times in the same location.1.2 This specification does not cover the safe and proper use of finger cots or products of special construction for special use.1.3 The values stated in SI units are to be regarded as the standard.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.