【国外标准】 Standard Guide for Testing of Hazardous Materials (Dangerous Goods) Packagings

4.1 The UN performance tests are based on the degree of hazard presented by the proposed hazardous material(s) to be packaged.4.2 Substances and articles which are hazardous are assigned to a specific packing group as defined in 3.8.1 and may be determined by referencing 49 CFR 172.101 hazardous materials table.4.3 Only packaging designs that have been successfully tested to the UN performance standards as defined in 3.8.2 may have the UN specification mark applied to the outer packaging. Hazardous Materials may not be transported in a packaging that does not bear the appropriate UN specification markings unless otherwise authorized by the applicable competent authority.4.4 Packages successfully tested to the UN performance standards may or may not withstand the North American distribution environment. To further evaluate the suitability of the package it is strongly recommended that additional tests as detailed in Practice D4169 or other carrier specified test requirements be conducted.AbstractThis guide identifies the key information required to ensure that selected packaging will pass the United Nations (UN) packaging certification at the level that is appropriate for its intended use. This guide covers test procedures for transportation of hazardous material packagings for net masses except those used for infectious substances, radioactive materials, cylinders, and other receptacles for gases and does not replace domestic or international requlatory requirements for hazardous material packagings. The UN performance tests are based on the degree of hazard posed by the proposed materials to be packaged which are also assigned to a specific packing group. Only packaging designs that meet the UN performance standards are to be marked with a UN mark. Tests include drop test, leakproofness test, stack test, vibration test, pressure differential test, hydrostatic pressure test, and cobb water absorption test.1.1 This guide identifies the key information required for United Nations (UN) packaging certification to ensure the selected packaging will be certified to the appropriate level for its intended use and provides guidance for locating relevant sections of the United States Department of Transportation Title 49 Code of Federal Regulations (CFR). Consult with a regulatory specialist whenever needed.1.2 This guide provides assistance in determining the appropriate performance tests required to certify packaging designs to the United States Department of Transportation Title 49 Code of Federal Regulations performance oriented packaging standards based on the United Nations Recommendations on the Transport of Dangerous Goods..1.3 This guide covers the testing for transportation of hazardous materials (dangerous goods) packagings for net masses not exceeding 400 kg (880 lb) or capacities not exceeding 450 L (119 gal), excepting packagings for infectious substances, radioactive materials, cylinders and other receptacles for gases.1.4 This guide does not replace domestic or international regulatory requirements for hazardous materials packaging but is strongly recommended to be used in conjunction with those regulations.1.5 The user of this guide must be trained in accordance with the United States Department of Transportation Title 49 Code of Federal Regulations (49 CFR) as required by 172.700 and should be familiar with other applicable hazardous materials regulations such as: International Civil Aviation Organization (ICAO) Technical Instructions for the Safe Transport of Dangerous Goods by Air, and the International Maritime Dangerous Goods Code (IMDG Code) and carrier rules such as International Air Transport Association (IATA) Dangerous Goods Regulations.1.6 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.