【国外标准】 Standard Practice for Identification of Standard Electrical Steel Grades in ASTM Specifications

This practice explains the procedure for identifying standard grades and types of flat-rolled electrical steels in ASTM electrical steel specifications. This practice applies to flat-rolled magnetically soft irons and steel such as low-carbon steels and alloys of iron with silicon, aluminum, and so forth produced to a specified thickness and maximum value of core loss. These designations are intended to replace the old AISI M designations which are no longer supported. The practice also has a cross-reference between thickness and electrical sheet gage number.1.1 This practice covers the procedure for designating (within ASTM specifications) standard grades of flat-rolled electrical steels made to specified maximum values of specific core loss. This practice applies to magnetically soft irons and steel (low-carbon steels and alloys of iron with silicon, aluminum, and other alloying elements) where a core loss measurement at a stated peak value of alternating induction and a stated frequency, such as 1.5 T (15 kG) and 60 Hz, is normally used to grade the material. This practice also applies when some other property is specified (or a different induction or frequency, or both) as the limiting characteristic, provided the material also meets all the requirements of the ASTM specification.1.2 Individual specifications that are in conformity with this practice are Specifications A677, A683, A726, A876, and A1086.1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to customary (cgs-emu and inch-pound) units which are provided for information only and are not considered standard.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.