【国外标准】 Standard Test Method for Rubber Property—Resilience by Vertical Rebound

4.1 Resilience is a function of both dynamic modulus and internal friction of a rubber. It is very sensitive to temperature changes and to depth of penetration of the plunger. Consequently, resilience values from one type of rebound instrument may not, in general, be predicted from results on another type of rebound instrument.4.2 This test method is used for development and comparison of materials. It may not directly relate to end-use performance.1.1 This test method covers the determination of impact resilience of solid rubber from measurement of the vertical rebound of a dropped mass.1.2 This test method is not applicable to the testing of cellular rubbers or coated fabrics.1.3 A standard test method for impact resilience and penetration of rubber by a rebound pendulum is described in Test Method D1054.1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.