【国外标准】 Standard Specification for Medical Screwdriver Bits

This specification covers the acceptable material and dimensional requirements, and tolerances for bits of screwdrivers used for inserting and removing metal screws applied in surgical implants. The medical screwdrivers are available in the following types: Type I—single-slot bit; Type II—cruciate-slot bit; Type III—cross-slot (modified Phillips) bit; Type IV—hexagonal bit; Type V—square bit; Type VI—hexalobe bit. The bit and shaft portion should be fabricated from either martensitic stainless steel or cold worked cobalt-chromium-tungsten-nickel alloy, as specified. The portions should also meet specified values of Rockwell hardness.1.1 This specification covers the acceptable dimensions and tolerances for bits of screwdrivers to insert and remove metal screws used as surgical implants.1.2 This specification is based, in part, upon ISO 8319-1, ISO 8319-2, and ISO 10664.1.3 The screwdrivers with the bits described in this specification are suitable for use with screws described in Specification F543, ISO 5835, and ISO 9268.1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.