
【国外标准】 Standard Practice for Measuring Dynamic Characteristics of Water Slide Systems Using Instrumented Humans
本网站 发布时间:
2024-02-28
开通会员免费在线看70000余条国内标准,赠送文本下载次数,单本最低仅合13.3元!还可享标准出版进度查询、定制跟踪推送、标准查新等超多特权!  
查看详情>>

适用范围:
4.1 This standard practice is intended for use whenever the dynamic characteristics of a water slide are to be determined using instrumented humans.4.2 The use of this standard practice does not preclude the substitution of other published Amusement Industry accepted standard practices developed for use on water slides.4.3 The existence of this practice is not intended to imply that there is a requirement to perform specific accelerometer testing on water slides.1.1 This practice covers the acquisition of quantitative data related to the dynamic characteristics of water slides when taken with instrumented humans.1.2 Prior to the use of this practice, the designer/engineer shall have completed and approved the testing of a new slide such that it is reasonably expected to meet the performance requirements, including accelerations, of Practice F2376-21 and ensure the slide is safe for human testing.1.3 This practice shall not apply to:1.3.1 Any other amusement rides or devices, other than water slides and water slide systems as classified by Practice F2376-21.1.3.2 Non-human accelerometer testing on water slides or water slide systems as defined by Practice F2376-21.1.4 Units—The values stated in SI units are to be regarded as the standard. Other units of measurement are included in this standard for information only and are not considered standard.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
标准号:
ASTM F3493-23
标准名称:
Standard Practice for Measuring Dynamic Characteristics of Water Slide Systems Using Instrumented Humans
英文名称:
Standard Practice for Measuring Dynamic Characteristics of Water Slide Systems Using Instrumented Humans标准状态:
Active-
发布日期:
-
实施日期:
出版语种:
- 推荐标准
- ASTM D4619-12(2018) Standard Practice for Inspection of Linings in Operating Flue Gas Desulfurization Systems
- ASTM D4623-16 Standard Test Method for Determination of In Situ Stress in Rock Mass by Overcoring Method—Three Component Borehole Deformation Gauge
- ASTM D4625-21 Standard Test Method for Middle Distillate Fuel Storage Stability at 43 °C (110 °F)
- ASTM D4626-23 Standard Practice for Calculation of Gas Chromatographic Response Factors
- ASTM D4630-19 Standard Test Method for Determining Transmissivity and Storage Coefficient of Low-Permeability Rocks by In Situ Measurements Using the Constant Head Injection Test
- ASTM D4631-18 Standard Test Method for Determining Transmissivity and Storativity of Low Permeability Rocks by In Situ Measurements Using Pressure Pulse Technique
- ASTM D4634-16(2022) Standard Classification System and Basis for Specification for Styrene-Maleic Anhydride Molding and Extrusion Materials (S/MA)
- ASTM D4636-17 Standard Test Method for Corrosiveness and Oxidation Stability of Hydraulic Oils, Aircraft Turbine Engine Lubricants, and Other Highly Refined Oils
- ASTM D4637/D4637M-15(2021)e1 Standard Specification for EPDM Sheet Used in Single-Ply Roof Membrane
- ASTM D4638-16(2023) Standard Guide for Preparation of Biological Samples for Inorganic Chemical Analysis
- ASTM D464-15(2020) Standard Test Methods for Saponification Number of Pine Chemical Products Including Tall Oil and Other Related Products
- ASTM D4647/D4647M-13(2020) Standard Test Methods for Identification and Classification of Dispersive Clay Soils by the Pinhole Test
- ASTM D465-15(2020) Standard Test Methods for Acid Number of Pine Chemical Products Including Tall Oil and Other Related Products
- ASTM D4651-14(2020) Standard Specification for Isobutane Thermophysical Property Tables
- ASTM D4653-87(2020) Standard Test Method for Total Chlorides in Leather