【国外标准】 Standard Specification for Heat Resistant Aluminum-Zirconium Alloy Wire for Electrical Purposes

AbstractThe specification covers heat resistant aluminum-zirconium alloy round wire for electrical purposes. There is a family of aluminum-zirconium alloys that are used for heat resistance, which differ by zirconium content, tensile strength, electrical conductivity, and maximum use temperature. The aluminum wire shall be made from drawing stock. The materials shall conform to the required mechanical properties such as tensile strength and elongation. Heat resistance, electrical resistivity, and diameter of the wire shall be measured. The density of aluminum-zirconium alloy shall be taken for the purpose of calculating mass, cross-section, and so forth. Wire shall be supplied in one continuous lengths of reel. coil, or spool. Joints may be made in the drawing stock or wire prior to final drawing by electrical-butt welding, cold-pressure welding, or by electric-butt, cold-upset welding.1.1 This specification covers heat resistant aluminum-zirconium alloy round wire for electrical purposes. There is a family of aluminum-zirconium alloys that are used for heat-resistance (that is, resist annealing), which differ by zirconium content, tensile strength, electrical conductivity, and maximum use temperature. This standard covers one currently commercially applicable alloy from this family.1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.