【国外标准】 Standard Specification for Throat Protective Equipment for Hockey Goaltenders

This specification covers performance requirements and corresponding test methods for throat protectors marketed, sold, and intended for use by ice hockey goalkeepers. It aims to reduce the risk of injury to the throat without compromising the form or appeal of the game. To this end, the protector shall be used as intended within the rules of the game and in accordance with the manufacturer's instructions.This specification includes a protocol for testing throat protectors, which covers: construction, coverage, marking, and information relevant to users as well as sampling, low-temperature conditioning, determination of Head-Positioning Index (HPI) and puck impact resistance, and information that must be contained in the test report.1.1 This specification covers performance requirements and test methods for throat protectors marketed, sold, and intended for ice hockey goalkeepers.1.2 The intent of this specification is to reduce the risk of injury to the throat without compromising the form or appeal of the game. To do so, the protector shall be used:1.2.1 As intended within the rules of the game and1.2.2 In accordance with the manufacturer’s instructions.1.3 Ice hockey is a sport with intrinsic hazards associated with the normal conduct of the game. Participation in ice hockey implies the acceptance of some risk of injury. Use of a throat protector certified to this specification will not prevent all injuries.1.4 This specification has been prepared after careful consideration of the frequency and mechanisms associated with throat injuries that can potentially occur within the rules of the game of ice hockey.1.5 Requirements and the corresponding test methods, where appropriate, are given for the following:1.5.1 Construction,1.5.2 Puck impact resistance,1.5.3 Coverage,1.5.4 Marking and information.1.6 Throat protection is intended for use by goalkeepers.1.7 Use of the singular does not exclude the plural (and vice versa) when the sense allows.1.8 Although the intended primary application of this specification is stated in this scope, note that it remains the responsibility of the users of this specification to judge its suitability for their particular purpose.1.9 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.1.10 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.11 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.