【国外标准】 Standard Specification for Radiation Attenuating Protective Gloves

This specification describes the requirements for packaged, thin film medical protective gloves with radiation attenuating properties intended to protect the operator or other persons from unnecessary exposure to radiation during radiological procedures by providing an attenuating barrier to radiation. It specifies the minimum attenuation values and physical property requirements for these radiation-attenuating gloves, which must be compounded from natural rubber latex, rubber cement or synthetic polymers. This specification also covers labeling requirements.1.1 To describe the requirements for packaged protective gloves with radiation attenuating properties intended to protect the operator or other persons from unnecessary exposure to radiation during radiological procedures by providing an attenuating barrier to radiation. Minimum attenuation values will be defined.1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.